Coal Power Plants preventive maintenance

Start with the real operating context: duty, environment, consequence of failure, manufacturer guidance and the people who perform the work. A CMMS should preserve that context on the asset and place the relevant steps on each work order. It should not replace engineering judgment or a site-specific risk assessment.

Create a small initial task library, then improve intervals and evidence requirements from actual findings. The same model supports planned inspection, preventive replacement, calibration, lubrication, condition readings and corrective repair. Keep the result attached to the asset so the next decision uses history rather than memory.

• Define the asset hierarchy and criticality
• Capture manufacturer instructions and safe work requirements
• Create recurring inspection and service procedures
• Record findings, actions, parts and verification
• Review repeat failure and overdue work evidence

• Aging equipment management
• Spare parts availability
• Technician scheduling coordination
• Regulatory requirement compliance
• Performance monitoring systems
• Energy efficiency optimization

Each record should state which asset and site were involved, the operating symptom, priority, responsible person, procedure version, safety context, readings, evidence, parts used, time spent, failure code when relevant, specific root cause, action taken and verification result. That is enough detail to support the next technician, a planner and a reliability review without forcing every person through the same interface.

PreventiveHQ snapshots procedure steps onto the work order and stops closure when required steps or close-out evidence are missing. It reports unavailable metrics when no trustworthy denominator exists. Those controls are more valuable than a polished chart built from “done” notes.